Reading and writing was very good if not better than years ago. Very, very much appreciated — worked perfectly and saved me time hassle and, perhaps, money. Hi Kurt, not sure. Robert, My applogies for not seeing this until now. Apparently, WinXP bit can use the aic78u2.

Uploader: Kigara
Date Added: 15 August 2018
File Size: 19.86 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 29825
Price: Free* [*Free Regsitration Required]

Instead of typing in the hardware ID, I copied and pasted it into the. Finally I found a post where a guy said, another poster has posted a downloadable. Have you tried going back to the 32 bit drivers after making the alterations?

I loaded the drivers. Can you possible ac78xx your working file here so I can figure out what my problem is. Thanks a Lot Bro!!!

Anyway, I got it working, instantly the tape drive was added to device manager, once the Adaptec driver installed successfully. I did learn something about driver editing though so it was not a complete waste of time trying to get the other one to work. Perhaps you could correct my mistake.


aic78xx_aic78u2_vista_x86_vexe | DriverZone

How can i map the port so i can be able to install the printer on that port and able to use the scsi. Thank you so much for doing this and more importantly for sharing. I disabled driver signing, installed legacy device in dev manager, still no go.

My issue comes on the port mapping inwindows 7. Ahhh, the Adaptec UW scsi controller needs a driver installed. Hi Steve One more thing: I followed your instructions and after rebooting the drive was online in Windows This page and the instructions how to install an unsigned driver on Windows 8 at http: If anyone is interested just let me know.

Lo and behold, there were no Win7 drivers to run the card. Any additional information you can provide would be helpful so that others can avoid the issue.

SCSI on Windows 10 64-bit: Adaptec AHA-2940 (29xx) Ultra, AIC-7870 (78xx), or 29320LPE Ultra 320

So, I suspect that there is an incompatibility between the Vista bit driver and my card. This device cannot start Code You are commenting using your Facebook account. Just tried with a clean install of Windows 10 build and was able to install the driver for my AU card. Correspondingly, the following section exists immediately after the above heading in both of these.


You are commenting using your WordPress. Thank you very much. The place to find device driver updates.

Any suggestions from anyone? Do you know where could be a problem?

This is a SCSI printer? The creator of the driver modified the 78xx drivers, if you look in the. So today I decided, OK, time to get the tape software installed on the newly rebuilt server I had 3 other scsi cards before and could not get them to aic78k2, but the exact model he used did not require any changes to the code.

Many thanks and Regards, Robert. Leave a Reply Cancel reply Enter your comment here

Author: admin