|Date Added:||18 April 2012|
|File Size:||57.27 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
In the latter state, all motors are off and the scope will not respond to commands from the lx200tps or the serial line. This driver works with either alt-az mounts like a dobsonian or equatorial mounts. The focuser driver conforms to the initial and only release at this time of the ASCOM focuser specification. The setup window which is probably open now allows you to adjust settings for your scope and your needs. Lunatico’s Seletek Focuser Software and drivers for the Seletek family of controllers.
The 16″ checkbox must be turned on in the setup window or slewing will not work properly.
Most programs such as MaxIm DL already have the needed focus controls built in. The driver allows the Park Position to be changed.
Micro Focuser all models Drivers for all models of the Micro Focuser line of precision focusers. After a Park command is completed, the software must be disconnected. Please follow the procedure given below to the letter or risk having pointing problems. If you move your scope or disengage the RA or Dec clutches, then you must power up and align your scope with the handbox before connecting from your software.
Meade LX200 GPS and Classic
Equatorial mounts do not need to be accurately polar-aligned although an accurate polar alignment will likely lead to a more satisfying observing lxx200gps. Once you have done the above, or any time you park the scope, you may power it down or leave it powered up with the “Scope parked Upon connecting from your software, the scope will be aligned and ready for use.
Again, the scope must be parked for auto-startup to work! You don’t have to set it again, unless you want to change to a new Park Position. The Acsom Classic scopes can be set up for other park positions.
Or sign in with one of these services Sign in with Facebook. This driver provides both telescope and focuser interfaces each of which may be used by separate programs. Upon connecting from your software, the scope will be aligned and ready for use.
The purpose of parking a scope is to allow a stationary scope to be powered up at a later time and not have to be synced or otherwise aligned.
ASCOM Meade Driver
Sign up for a new account in our community. The last option is the best for most users, but dome users should take the time to use option 2 and fill out the fields. I don’t really get why it needs to be so complicated just to get PHD to talk to the scope You may have noticed that there are two Meade drivers listed in lx200gpx Telescope Chooser: Posted February 9, Thus you can safely leave the scope powered up without ls200gps on the motors or the risk of tracking into the pier, cord wrap, etc.
This Meade driver is actually two drivers in one. The Autostar II can be unparked from software with or without a power cycle.