Maintenance Recharging and Replacing the Battery To replace the battery: The charge status is shown on the unit display lower left corner. Thanks to its memory capacity of data items and its built-in reporting software, the FOT facilitates data management and enables data transfer to a PC via USB connection. Being careful not to touch the soft end of the swab, moisten a cleaning tip with only one drop of isopropyl alcohol. The power meter behavior is totally determined by the source.

Uploader: Kisar
Date Added: 25 March 2012
File Size: 50.64 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 44141
Price: Free* [*Free Regsitration Required]

From normal operating mode, fpm6-00 down for a few seconds. FULL Storage memory full. Thanks to its memory capacity of data items and converter software, it facilitates data management and enables data transfer to a PC via USB connection. The FOT may contain up to three sources. This reduces the need for communication between the two technicians and decreases the potential for error.

EXFO FLS & FPM Light Source and Power Meter Kit | OLTS

You may enter up to 40 favorite wavelengths. Turn Pull Push 2. Repeat the procedure for each wavelength you want to reference if you use auto-switching mode, the power meter automatically references wavelengths one at a time. To change this wavelength, press again while it is displayed.


If these bundles are not totally correct for your requirements contact the team and we can put together a bundle to suit you. Pull out the old b battery using your fingers. To change the signal modulation: I’m selling my TomTom Rider gps.

A green border around the baseplate pfm-600 that it is for APC-type connectors. It transmits with a wavelength-identification digital encrypted protocol, so that any compatible unit—such as another FOT Optical Loss Test Set—can automatically use the proper calibration parameters. When backlight is activated, you must always press a button once to light the keypad, then press the actual button you want.

Remove the battery compartment cover, located at the back of the unit. Edit the wavelength value vpm-600 follows: Accessories, including but not limited to fuses, pilot lamps, batteries and universal interfaces EUI used with EXFO products are not covered by this warranty.

FPM | Power Meters | CWDM Measurement | LAN Certification

The Recall indicator is displayed with the last cable name, then the last saved value and its fiber Exxfo. Validity of specifications depends on operating conditions.

Fully charge it about 4 hours before using it for the first time. Get More For Less. Vpm-600 lets your router talk to If the reference source is far from the power meter, you can connect your source to the power meter to send the reference value. Thresholds are often supplied by system manufacturers and depend on the system deployed.


When you receive an auto-wavelength signal or when the source is in auto-switching mode, you cannot manually change the power meter wavelength. Complete old 24 volt battery pack, in working condition, free with turbine combination. Thanks to its memory capacity of fpk-600 items and its built-in reporting software, the FOT facilitates data management and enables data transfer to a PC via USB connection.

In this mode, the unit displays the minimum or maximum power value read up to now. You should change the CF after performing an offset nulling.

EXFO Fpm-600 Power Meter Fiber Optic Link & Optical System Handheld FPM 600 602x

To clean detector ports: Page 55 Maintenance Cleaning Fixed Connectors 5. R20 OR Getting Started Activating the Backlight Activating the Backlight When operating the unit in the dark, use the backlight to make data on the display more visible. Page 65 Troubleshooting Transportation Transportation Maintain a temperature range within specifications when transporting the unit.

Invisible laser radiation may be encountered at the output port.

Author: admin