LANIER MP 2550 DRIVER

Remove the roller assembly [D] Springs x2, Arms x2, Rollers x2 6. To prevent toner leakage, never loosen or remove the screws shown in the illustration below. Details vBulletin Mods by vBSocial. Photoconductor Unit PCU 1. If you replaced PCU components:

Uploader: Moogujind
Date Added: 22 June 2018
File Size: 50.84 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 60959
Price: Free* [*Free Regsitration Required]

Replace the cleaning blade [A] x2 Reinstallation: Remove the PCU from the machine.

When the drum surface is touched or becomes dirty, wipe it with a dry cloth or clean it with wet cotton. Make sure that the holes for the lanisr on the front and rear end of the PCU are aligned correctly.

Last updated on December 28, To prevent toner leakage, never loosen or remove the screws shown in the illustration below. Remove the rear shoulder screw [B] x1. Results 1 to 1 of 1. Tighten the top screw [F]. Make sure that the head of the stud is put in the correct position. Turn on the main power switch, and close the front door. Wipe with a dry cloth after cleaning with the cotton. Separate the top and bottom parts of the PCU.

  CTREE JDBC DRIVER DOWNLOAD

Ricoh B2050153, Drum Unit Black, 1027, 2027, MP2550, MP3350- Original

Remove the front screw [A] x1 5. Set the rear cover and front cover [B]. Replace the cleaning roller [F]. Install the PCU in the machine. Attached is a 3 page pdf of the settings and their lxnier. Release the front tab [C]. Set the bottom on the vinyl sheet. Leave a Reply Cancel reply You must be logged in to post a comment.

Yes, I know i’ve got to clean up that line on the output as well. After the machine turns the development roller for 10 seconds, go to the next step.

Toner Ricoh Aficio MP – MP – MP Compatible

Open and close the door two more times. Press and Hold the C key. Spread the vinyl sheet provided with the developer kit on a flat surface.

See Note in Bold Green above. Hold the pawl [A] by its sides, pull it down and slowly twist it away from the PCU.

  COMPAQ NX9420 SD CARD DRIVER

Ricoh Aficio MP / Lanier LD – NO! Network Connectivity –

I don’t mind loosing everything but the counters. If the holes are not aligned correctly, make sure that the tabs at the front, rear, and left side of the PCU are engaged correctly. Photoconductor Unit PCU 1. Turn the development roller gear [I] to remove toner from around the development roller.

Turn on the main power switch.

I’m trying to verify if this is a software or hardware problem. Have tried a regular cat-5 patch cable but have not created the crossover cable to rule out my network switch.

Remove the roller assembly [D] Springs x2, Arms x2, Rollers x2 6. While turning the black gear [K], slowly move the pack left and right and pour half of the developer over the auger [L].

Author: admin